• LazaroFilm@lemmy.world
    link
    fedilink
    English
    arrow-up
    16
    ·
    1 year ago

    Yep. Fuck MyQ. I ordered a $15 smart garage adapter and will solder the contacts at the wall button.

    • ikidd@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      Which adapter did you get? I’ve just built my own on but wouldn’t mind a less janky solution.

    • dmtalon@infosec.pubOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      I bought gocontrol units for my dumb garage door openers and had to build a relay system to get it to work with the intelligence wall plates as they were not just shorting out to trigger the door.

      But it should work with any new non smart opener if I wanna stay away from proprietary crap

      • LazaroFilm@lemmy.world
        link
        fedilink
        English
        arrow-up
        6
        ·
        edit-2
        1 year ago

        I have an intelligent 2.0 door, but I noticed that the mechanical switch on the wall controller is a simple contact switch on the PCB. The 12v “smart” wire cames out of the PCB to the motor. So I.a solder two wired out of that switch and it should work.

        Here is the pic of the wall switch PCB.

        • dmtalon@infosec.pubOP
          link
          fedilink
          English
          arrow-up
          2
          ·
          1 year ago

          Ya I wired the relay to that button on my wall unit to trigger the door since the signal wire between it and the motor wasn’t just a contact switch triggering it.

          • KairuByte@lemmy.dbzer0.com
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 year ago

            Careful with that, I’ve heard stories of the wiring picking up stray signals and opening the door without anything actually being sent.

            If you’ve got a myQ door, look into ratgdo. There’s even an esphome version.

            • dmtalon@infosec.pubOP
              link
              fedilink
              English
              arrow-up
              1
              ·
              1 year ago

              Interesting, this has been in place quite a while and we haven’t experienced random openings or closes.

              My openers are from 2009, and have no MyQ stuff . Chamberlain Elite units with motion/temp sensors on the wall unit. That is what caused my issues with using the gocontrol units directly. The wire between the wall unit and motor carries some signal and is not just shorted out to trigger the door.

                • dmtalon@infosec.pubOP
                  link
                  fedilink
                  English
                  arrow-up
                  1
                  ·
                  1 year ago

                  Ya, no… I bought a gocontrol garage opener to make mine smart, but its only designed to short the two wires together (simulating a door bell style button). Unfortunately, that just doesn’t work here since those wires are carrying data when connected to the enhanced wall units.

                  So, I bought a little project box, wired the gocontrol to a standard 12vdc relay with wires running from that to the wall unit. I soldered those to the physical button on the circuit board.