I dont know why they have to lie about it. At $5/8ft board you’d think I paid for the full 1.5. Edit: I mixed up nominal with actual.

  • BarqsHasBite@lemmy.ca
    link
    fedilink
    English
    arrow-up
    27
    ·
    edit-2
    6 months ago

    The convention is 2" before milling. Milling takes off 1/4"on each side, so the result is 1.5".

    • MisterFrog@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      6 months ago

      Is this a joke? (I know it isn’t).

      Why would I want to know the dimensions of the unfinished product? I’m not a construction worker, so honestly is there any reason?

      • BarqsHasBite@lemmy.ca
        link
        fedilink
        English
        arrow-up
        1
        ·
        6 months ago

        I can only think it was when the lumber mill was the dictator of terms. That’s what they put out, so that’s what it was.

    • dan1101@lemm.ee
      link
      fedilink
      English
      arrow-up
      3
      arrow-down
      2
      ·
      6 months ago

      Why was that ever accepted? I don’t care what size it was before milling. If I buy a 2x2 I want a 2x2.